Spray Bouncing Off the Leaf? Fix Surface Tension Before You Add More Active

Hits: 275 img

When a drone spray fails, the first instinct is usually more active ingredient. In most cases the real problem sits one step earlier: the spray never stayed on the leaf. Anhui IOTA Silicone Oil Co., Ltd. supplies agricultural silicone adjuvants to formulation houses and spraying services, and the same question comes up repeatedly — how much adjuvant, and under which conditions.

Why droplets bead up and roll off

Leaves are covered with a waxy cuticle: a low-energy surface. A plain spray solution carries a surface tension around 70 mN/m, far above what is needed to wet that surface. The droplet stays spherical, and the smallest tilt sends it to the ground. Product that reaches the soil does not control the pest and is not absorbed by the plant.

Lowering surface tension is the only effective route. Organosilicone adjuvants are modified silicone surfactants designed for exactly this: they reduce the surface tension of the spray liquid so droplets spread rapidly across the waxy surface and penetrate through the stomata.

How much: dose by weather, not by habit

The complication in aerial application is that the same field and the same tank behave differently at dawn and at noon. The IOTA 331 technical data sheet therefore gives a range that moves with conditions:

Conditions

Addition rate (% of spray volume)

Reference reduction in active ingredient

≤27 °C, RH >60%, wind <4 m/s

1–1.5%

30–40%

>28 °C, RH <50%, wind >4–5 m/s

1.5–2%

20–40%

Excessive wind

Spraying not recommended

—

Figures as stated in the IOTA 331 product data sheet. Actual performance depends on crop, formulation, water quality and application parameters, and should be adjusted in the field.

Typical properties listed in the same sheet: yellow to brown-red clear liquid, active content >99%, anionic/non-ionic, pH 6–8, surface tension 26.0–31.0 mN/m (1% in water, 25 °C), penetration time 30 s–1 min (1% in water, 25 °C). The recommended procedure is to mix the pesticide with water first, then add 1–2% of the adjuvant by spray volume and mix again before spraying.

For powder formulations, the route is different

Not every product is a liquid concentrate. IOTA 2001 is a powder agricultural silicone synergist: white to pale yellow powder, 50% active content, designed for wettable powders (WP), granules (GR), water-dispersible granules (WDG), soluble powders (SP) and effervescent formulations (EA), at 1–10% of the formulation, typically around 4%. It can also be added to powder foliar fertilisers to lower spray surface tension and reduce water use. The practical advantage is that a dry powder disperses evenly in a powder line, where a liquid adjuvant often does not.

Three checks before you choose

  1. Surfactant system compatibility — anionic, cationic and non-ionic components can interact; run a small-sample compatibility test first.
  1. Water hardness — hard water consumes part of the adjuvant's efficiency; adjust for local water.
  1. Application weather — the first variable controlling dosage, ahead of habit.

Contact IOTA for product specifications, or to discuss dosage against your own application conditions.


Recommend

    Online QQ Service, Click here

    QQ Service

    What's App